I think you may have just shared a purchased pattern.....
I think you may have just shared a purchased pattern.....
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Ok, that's one of the "other issues" I mentioned. Using a gray scale image black is the top of the board and white is the bottom. You should invert the image in photoshop or other graphics program before making a pattern from it.
Last edited by TerryT; 11-06-2014 at 08:23 PM.
My bad I had no idea I took it down
Where did you get the blank helmet and jersey?
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors
Here's the site where you can get it….
http://cncminiprojects.com/project-shop/
Here are a few more designs I did with the CNC mini Projects helmet. You can do a lot with them. These were not done on my Carvewright but can do done with it.
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Tom,
I love he 49er project I am a big 49er fan this is one I will have to try.