Looking for a bull terrier pattern. Can anyone help?
Looking for a bull terrier pattern. Can anyone help?
Can you post a picture of what you want?
I will see what I can do after work if no one else comes up with something. (This looks like a job for the new Sculptor.)
Here is an attempt. A bit flat. All I can do for now.
Here are two each, almost the same.
Last edited by eelamb; 10-23-2014 at 09:03 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Works GREAT. Thank you.