Junior Member
Looking for help with logo
A few weeks ago I posted a thread about a friend who recently retired from the fire department. Today I checked back with him because search of logo images was not satisfying me. I was able obtain a photo, after doing some adjustment in photo program, I imported to designer. The image is not as clear and smooth as I would like. If anyone has a pattern already they would consider sharing I would be greatly appreciative. The logo (see attached) is for International Association Fire Fighters.
CarveWright Staff
https://store.carvewright.com/produc...92&cat=&page=5
Maltese Cross - pattern on the Depot. $8
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Senior Member
Try importing this image. May want to invert it after importing so letters are recessed.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Junior Member
How's this
Senior Member
Will this work for you?Originally Posted by Bob Victor
A few weeks ago I posted a thread about a friend who recently retired from the fire department. Today I checked back with him because search of logo images was not satisfying me. I was able obtain a photo, after doing some adjustment in photo program, I imported to designer. The image is not as clear and smooth as I would like. If anyone has a pattern already they would consider sharing I would be greatly appreciative. The logo (see attached) is for International Association Fire Fighters.
Will this work for you?
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
Posting Permissions
Reply With Quote