I thought I've seen a light switch plate in the pattern depot but can't seem to find it. Does someone have a clue?
Thanks
Suzanne
I thought I've seen a light switch plate in the pattern depot but can't seem to find it. Does someone have a clue?
Thanks
Suzanne
I have a 4 and a 5 switch plate that I did along with a round top single that someone else did if any are of interest.
Rick H
There are a bunch on the Forum...try search Wall switch plates
Yes ASKBUD made most of them in the pattern store
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Thank all I found it finally.
How about most in one spot.
Some more some cutouts I made too.
Then there is the book dual plate I made. It is too large to fit here so you will have to ask for it by PM and give me an email address to send it to.
Edit: sounded like I am taking credit for the creation of the plates. Only a few were made by myself.
Last edited by eelamb; 05-15-2015 at 02:55 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Thx Ed ... I might give a few of these a carve ...
Kevin
Middletown, NJ
Mans Quest for knowledge,,, means he'll always find a way !!