I received this pattern in one of the wood magazine that I get, I think that I need to use the sweep tool for the inside of the handle but I'm at a loss for the outside radius. I am using the import image file, any advice would be welcome.
I received this pattern in one of the wood magazine that I get, I think that I need to use the sweep tool for the inside of the handle but I'm at a loss for the outside radius. I am using the import image file, any advice would be welcome.
this is the completed book self when its done..
I enlarged the drawing I think
Off and running...so glad to see these uses of the suites!! They are powerful tools, once you learn how to use them. I'm embarrassed to say, I don't know much. Not even enough to show you. It takes imagination, but I think there is a practical way to learn this; a logical approach.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
I have done the sweep tool for around the inside of the handle that was easy enough...but the 1/4 chamfer and the 3/8 on the handle elute me, the angle on the 1/4 chamfer has me stumped and the 3/8 on the outside, the 1/8 round over I can do with a sander... I wanted to delete this post ..... It didn't work !!
Last edited by aokweld101; 08-12-2014 at 08:43 AM. Reason: wrong mpc
I have done the sweep tool for around the inside of the handle that was easy enough...but the 1/4 chamfer and the 3/8 on the handle elute me, the angle on the 1/4 chamfer has me stumped and the 3/8 on the outside, the 1/8 round over I can do with a sander...
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
Last edited by aokweld101; 08-12-2014 at 12:23 PM.
Could someone post a picture of where we're at? I can't get the thing to boarder correctly. Feather goes on both sides of ptn.
thanks so much!
karl