very impressive like your design
Henry
Every one has a photographic memory. Some just don't have film.
Man that is some great work. Did you do that top with standard designer and bits or with the deep bits and Version 2.0 or greater?
Great work looks wonderful.
Thanks for the comments. The top was done 1.87 3d. Its the pull in a picture and trace, sweep and extrude. Then turned it into a ptn. Don't think I'll use the decorative bits much with 3d..
I don't have a very good internet connection so I'm not for sure how much I'm missing with the new software.
Can you tell how tall the secretary is? 4' 2"
thanks so much!
karl
WOW Karl! Truly impressive work.
Fair winds,
Capt Bruce
Kinney deSigns http://kinneydesigns.us
CarveWright START U Team Member.
30 year USN SEABEE, the original Weapons of Mass Construction.
Designer Ver 1.187 and 2.007, Ver.3.001 One 2009 B CW w ROCK and a 5th Year Anniversary C CW
Rotary Jig, 2D and 3D, Tracing Probe, DFX and STL Importers
.
Karl very nice. Like the rap around molding on top.
Karl, really nice rendition of a block front! Amazing what the CW is capable of producing...
Wow wee !!!
Mans Quest for knowledge,,, means he'll always find a way !!