Two questions concerning the attached MPC. First, is there a way to rotate something like this so it can be cut on a 7" wide board? Also, the thickness is set to .250, I thought the minimum was .500? Thanks!
indian feather cut out.mpc
Two questions concerning the attached MPC. First, is there a way to rotate something like this so it can be cut on a 7" wide board? Also, the thickness is set to .250, I thought the minimum was .500? Thanks!
indian feather cut out.mpc
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors
Thanks Steve, unfortunately I can't use the dfx file and I have the old version software. Guess I really need to upgrade.
Kansas Wood Shop
Disabled Veteran owned and operated
Visit www.kansaswood.com
A machine with rock, CS machine, Designer 3, centerline, conforming vectors
You can use DXF with the old version of the software you just need to purchase the license. I use it with 1.187 and 2.07
If I had DXF importer I would import it for you maybe someone who has it will import it into 1.87 mpc for you.
Here is the MPC in 1.187. Again, You may have to clean it up a little.
Last edited by SteveNelson46; 07-30-2014 at 05:27 PM.
Steve