Western Vector Patterns

[dehrlich]

Wondering if someone could create vector MPC's for me from the attached please. I just have the basic old version pattern software. You could put them all on the same "board" and i'll cut and paste from there. I would really appreciate it!

Is there a program I can use to create these then just paste the paths into the CW software? Thanks

[blhutchens]

Do you have pattern editor?
I imported the image, made a pattern, loaded it into a new project, outlined it and deleted the pattern

[dehrlich]

No I don't have the pattern editor.. yet. Thank you so much!

[bjbethke]

Wondering if someone could create vector MPC's for me from the attached please. I just have the basic old version pattern software. You could put them all on the same "board" and i'll cut and paste from there. I would really appreciate it!

Is there a program I can use to create these then just paste the paths into the CW software? Thanks

Will this work? - you need centerline and load the font to your computer. BJB

[brdad]

Outlining works decent as long as you don't need or want to edit the images any. Often the outlined images are not as smooth as they could be either. I generally will make a custom woods file for the image and then trace the images with Designer.

[SteveNelson46]

Wondering if someone could create vector MPC's for me from the attached please. I just have the basic old version pattern software. You could put them all on the same "board" and i'll cut and paste from there. I would really appreciate it!

Is there a program I can use to create these then just paste the paths into the CW software? Thanks

You may have to clean these up a little.

[SteveNelson46]

Here is the all in one. I used Corel Draw with the "Outline Trace as a Technical Illustration" then exported as a .dxf.