Hello. Thinking of getting a machine OR someone to cut some stuff for me

[vdubjim]

Im debating getting a machine, or someone to cut some stuff for me. its price and the room i have vs. time etc lol.

[tcough3475]

Welcome to the forum. The machine and software are very easy to use as a beginner, but as you progress, it offers some really sophisticated abilities that will match most CNCs out there. It has it limitations, but for the cost, it's a great way to get your feet wet. If you have time, you can do some really great things.

If you need help instead, let us know what your after and the right person will come along.

[vdubjim]

Looking to make some wall plaque versions of this pin..
http://www.ebay.com/itm/like/141329990560?lpid=82

[myshop1044]

Hi vdubjim
Go to the Carve wright web site and look for a Start U member in you state and maybe they can help with your decision to buy and or help with you project.

Perry B.

[edzbaker]

When you get the machine, come back here and get the pattern for the carve that you are wanting. To machine owners, this Forum has more value than you can imagine.


Ed

[vdubjim]

thanks. that drawing is definitely a step in the right direction, few areas are not detailed enough though.

I looked at the site and contacted someone. if its like most things in this area, i will not hear from them.

[henry1]

here is a couple more That I can help with when ever those are USAF

[vdubjim]

Pilot wings are cool. I'd take a few sets of those.
The pin I showed would be same wings, just a prop and radial engine, flight engineer wings.