Designer 3.0 is NOW AVAILABLE

[lynnfrwd]

Purchase here, if upgrading from Designer 2.0: http://store.carvewright.com/product...=24956&cat=399

Purchase here, if upgrading from Designer 1.187 or older version: https://store.carvewright.com/produc...roductid=24957

See tutorials and features, as well.

New photos under CONFERENCE tab and on Facebook at https://www.facebook.com/CarveWrightCNC

[dltccf]

Just to confirm what it says in the "Read This Important information first". If I have 1.187 already installed I must uninstall it before I can install 3.0?

dave

[RMarkey]

No, you can leave 1.187. You can't run both at the same time, though.

[dltccf]

Ok thanks

dave

[James RS]

Question, is Designer compatible with Windoes 8?

[Lobo]

Thanks for the post. Do you know if the problem with tabs "corrupting" carvings in 2.006 & 2.007 has been corrected in 3.0?

[lynnfrwd]

Question, is Designer compatible with Windoes 8?

YES!, but you MUST use the Run as Administrator command to both install it and register it, just like with 1.187 or 2.0 on Windows Vista, 7 and 8.

[jab73180]

So you can bypass 2.0 altogether?

[mtylerfl]

So you can bypass 2.0 altogether?

Yes - going from 1.187 to version 3, no problem.

[jab73180]

Yes - going from 1.187 to version 3, no problem.

Thank you, always helpful.