Rotary Lithophanes!!

[sunmiztres]

I do not think it is distorted. I think you just did not use bit optimization best.

I did use best as the bit optimization. Took 2 1/2 hours to carve. On the MPC you can see the bit setting. IT is an old picture from back in 1988. If you look at the eyes from the original to the litho you can see what I mean or it may just be me.

[CNC Carver]

That looks very nice.
Jeff

[bergerud]

I did use best as the bit optimization.

Ok, but on the mpc you posted Bit Optimization was none.

[sunmiztres]

Ok, but on the mpc you posted Bit Optimization was none.

after I carved the original I went back to the MPC to see if unchecking "scale to fit board" would help and must not have not done the bit optimization again. It was optimized during the carve.

[rcdages]

sunmiztres

Wonderful litho. Great carve.

[sunmiztres]

sunmiztres

Wonderful litho. Great carve.

Thank you.

[mikemi]

Personally I think it looks fine. I still haven't played around with carving pvc on the rotary jig but I have been reading all the posts about it here on the forum.

Mike