Page 7 of 7 FirstFirst ... 567
Results 61 to 67 of 67

Thread: Rotary Lithophanes!!

  1. #61
    Join Date
    Sep 2010
    Location
    Hereford, AZ
    Posts
    236

    Default


    0 Not allowed!
    Quote Originally Posted by bergerud View Post
    I do not think it is distorted. I think you just did not use bit optimization best.
    I did use best as the bit optimization. Took 2 1/2 hours to carve. On the MPC you can see the bit setting. IT is an old picture from back in 1988. If you look at the eyes from the original to the litho you can see what I mean or it may just be me.

  2. #62
    Join Date
    Dec 2011
    Location
    Spring Arbor Michigan
    Posts
    1,276

    Default


    0 Not allowed!
    That looks very nice.
    Jeff

  3. #63
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,157

    Default


    0 Not allowed!
    Quote Originally Posted by sunmiztres View Post
    I did use best as the bit optimization.
    Ok, but on the mpc you posted Bit Optimization was none.

  4. #64
    Join Date
    Sep 2010
    Location
    Hereford, AZ
    Posts
    236

    Default


    0 Not allowed!
    Quote Originally Posted by bergerud View Post
    Ok, but on the mpc you posted Bit Optimization was none.
    after I carved the original I went back to the MPC to see if unchecking "scale to fit board" would help and must not have not done the bit optimization again. It was optimized during the carve.

  5. #65
    Join Date
    Oct 2007
    Location
    Conroe, Texas, United States
    Posts
    1,550

    Default


    0 Not allowed!
    sunmiztres

    Wonderful litho. Great carve.
    Happy Carving

    Robert D.
    rcdages

    CarveWright START U Team Member.

    The mightiest oak in the forest is just a little nut
    that held it's ground.

  6. #66
    Join Date
    Sep 2010
    Location
    Hereford, AZ
    Posts
    236

    Default


    0 Not allowed!
    Quote Originally Posted by rcdages View Post
    sunmiztres

    Wonderful litho. Great carve.
    Thank you.

  7. #67
    Join Date
    Nov 2007
    Location
    Redmond, Or
    Posts
    359

    Default


    0 Not allowed!
    Personally I think it looks fine. I still haven't played around with carving pvc on the rotary jig but I have been reading all the posts about it here on the forum.

    Mike
    All Gave Some,
    Some Gave All.

    My computer configuration and software used:
    Gigabyte GA-990XA-UD3 Motherboard, AMD FX 6-core Processor Black Edition, 32 Gig DDR 3 Ram, Gigabyte HD 6450 Video Card with 1 Gig DDR 3 ram, Windows 10
    Designer 2.007, Designer 3.102, Pattern Editor, Centerline, Conforming Vectors, 2d Tools, 3d Tools, DXF Importer, STL Importer and Rotary Jig.

Page 7 of 7 FirstFirst ... 567

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •