Carve too deep warning

[cestout]

This is just an FYI. When I open rotary project where I have a rotary pattern (I mentioned making one in another thread) I get the too deep to carve warning. Checking the project diameters find no problems. It does not seem to inhibit uploading the project to the card.
Clint

[RMarkey]

That shouldn't happen. Make sure the correct bit is selected. Is there only a raster carve on the rotary?

[cestout]

It did have the wrong bit selected so I changed it, saved it, closed it and reloaded it, same thing.
Clint

[blhutchens]

Clint, look at the depth of the filigree on the outside. It is set at 75.00 .
I don't know why it looks like it would carve.

I found it by deleting the lion then it showed up.

Brent

[bergerud]

Clint, look at the depth of the filigree on the outside. It is set at 75.00 .
I don't know why it looks like it would carve.
Brent

It was set to additive.

[cestout]

Thanks. The details, every little one!
Clint

[SteveNelson46]

Clint,

Just messing around with your Lion Leg design and came up with this.

[cestout]

Interesting, but he wants filigree.
Clint

[SteveNelson46]

Interesting, but he wants filigree.
Clint

Here's another suggestion. Just trying to help when I can.