Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: How to carve a large circle carve region accross small width boards to glueup??

  1. #11

    Default

    What Michael said.

    I get very good results with Centerline and the locally available cedar.

    Click image for larger version. 

Name:	Chipped sign.jpg 
Views:	69 
Size:	289.3 KB 
ID:	70189

  2. #12
    Join Date
    Jul 2012
    Location
    Springtown, TX
    Posts
    676

    Default

    I have the same results from Texas cedar (I think it is a Juniper) as Michael.
    Some of that may be due to moister content…..but Centerline works better on soft wood even ponderosa pine and fir that have been kiln dried chip out on rasters.
    I have been using red oak for my raster carves with success.

  3. #13

    Default

    make the line disappear , what is the best way to make the Line joining boards in a carve disappear , I trimmed it then jointed the 2 halfs and glues and bisket the 2 halfs let it set after all done it looked good , Till stain was applied there it was a eye sore , I also applied wood filler and thought it would help , the filler bleeds thru , any ideas I used a dark maple stain

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •