Originally Posted by
Sliverfoot
My question is, and I have the original designer software (not version 2) I have no idea how to even start. Is this something that my Carvewrite can do, is this something my software can do?
Any input would be appreciated.
Yes you can create something like that in Designer #1, and the machine can do it.
I would be concerned with half-inch material, a little thicker would work better.
(avoid possible error messages, assure good roller pressure, and less flex on supports)
I'm having difficulty with the scale of the drawing, it appears that there are four
repetitions of the design in six feet, or about 10" X 72". Getting half-inch material that
big would be difficult in my area of the country.
Be sure to use adequate support on the ends of the board while carving.
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi