I just got the approval from the wife to purchase my unit and the sears store only had a open box. The board sensor has been replaced and know this because the old one was in the box. I had the z axis error got that fixed by plugging in the ribbon that I read about on the forums. Then I got the Y axis error and fixed that with the new firm ware upgrade now the machine appears to run fine and says it is starting cut motor but it just goes to insert bit. I pull the bit out and replace it and the machine goes through the motions and tells me to load bit. Is there something I can try because I feel someone has to have had the same problem and might be able to give me some pointers. I am so ready to get this thing up and running plus I picked it up for only 1400 out the door. Thanks in advance for any advice.
Nick