Tying to find a solution to the problem that I have with my machine.
It's smoking when it cross cuts and chewing up the board when it carves.
Mr. AL told me that i have a loose bearing.
Any solutions will be appreciated.
Thanks
George
Tying to find a solution to the problem that I have with my machine.
It's smoking when it cross cuts and chewing up the board when it carves.
Mr. AL told me that i have a loose bearing.
Any solutions will be appreciated.
Thanks
George
Loose bearing or worn out bit (especially now since it is burnt).
What kind o chuck are you using?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Do you see a part like this laying around? Look around in the bottom of the machine.
He has a new bit... Same problem... we have been trading emails for a while.
He upgraded the Chuck a while back.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Not a loose truck?
Likely a loose truck...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Or a fried lower bearing in the truck ... Mine did that when the bearing blew in mine then it also snapped my flex shaft ... My bearing cooked and seized ... Guess a top bearing could also do that ... Something else to check ... Oh, we're talking bout the spindle bearings in the truck ..
Mans Quest for knowledge,,, means he'll always find a way !!