I'm going to have to go back and go threw the tutorial but thanks Dan, If not for you I would still be dumbfounded, after I figure this out I have some more question on making of my own STL files. That can wait till another time...Thanks Dan !
I'm going to have to go back and go threw the tutorial but thanks Dan, If not for you I would still be dumbfounded, after I figure this out I have some more question on making of my own STL files. That can wait till another time...Thanks Dan !
I have what I think it needs to be ...the problem is the same though the outside edges don't have the contour as it has on the STL
I think it is just feather. Choose feather - none. Looking good.
I turned the feather off and I still think the edges are not contoured maybe I'm wrong or I'm not doing something right..
Looks good to me.
I guess the best thing to do is run one of the patterns to see if to if its right at least give me peace of mind. Thanks Dan I have a lot more questions but I will wait my brain is fried..
I couldn't sleep I had a nightmare about this bowl, I thought that since you could make a pattern on the front and back of the board that instead of making the two carves and making it split the two boards at 1.125, to make the top and bottom pattern so I made the top 1.5 and the bottom carve at .75 to make the 2.25 and using three boards but as usual I hit another Quirk as I was downloading into the STL file doing the top pattern It crashes at about 97 percent downloaded and tells me to much run time and it done it twice. Some more input is needed....Thanks
Do you mean the importer crashes when importing the STL in the beginning or crashes when making a pattern at the end?
When importing the file at the beginning.
I think that that may be a memory problem. Maybe you have many programs open?