Oval rope pattern

[myshop1044]

attached is a metal sign that I want to recreate in general, so I would like to find a oval rope pattern
if one exist. This project will be about 10 1/2" in height and what ever length that would go along with height
and keep the oval shape. If anyone happen to have a oval rope pattern they would like to share this would be great.
I have a sq. , rectangle, and corner rope patterns, just no oval.

Perry B.

[Alan Malmstrom]

Doing a little practice with ropes and came up with this.

[fwharris]

Nice one Alan! There are a few places in the low spots that have hole though.. Easy to correct in PE..

[SteveNelson46]

attached is a metal sign that I want to recreate in general, so I would like to find a oval rope pattern
if one exist. This project will be about 10 1/2" in height and what ever length that would go along with height
and keep the oval shape. If anyone happen to have a oval rope pattern they would like to share this would be great.
I have a sq. , rectangle, and corner rope patterns, just no oval.

Perry B.

I just got back from a 2 week road trip and saw this post. The attached pattern is a rope oval that I had in my pattern repertoire. I resized it to 10.5 inches high and 21 inches wide but, since it is a pattern you can re-size it.

[myshop1044]

Thanks fellows for the help on the patterns, I'm heading out to the shop to test carve my project in foam.

[myshop1044]

This is newest version of the same pattern, but using the whole board
instead of the oval cut path.

[CNC Carver]

Looks good. I like the whole board with jaged edge.

[myshop1044]

hey look what I found, first Steve thanks for the pattern. I found 2 (looked like it was mirrored) marks
on each end of the project. I think it is connected to the rope ptn. I when back and looked at the project
and if you get very close you can see them on the outside of the rope ptn.
I noticed them when I started to cut the tabs on the oval of the board. It did not hurt the project, I just thought
I let you know, so you can look at your pattern.
see attached, I highlighted the flaws.

You never know what you are going to find.

Perry B.

[SteveNelson46]

hey look what I found, first Steve thanks for the pattern. I found 2 (looked like it was mirrored) marks
on each end of the project. I think it is connected to the rope ptn. I when back and looked at the project
and if you get very close you can see them on the outside of the rope ptn.
I noticed them when I started to cut the tabs on the oval of the board. It did not hurt the project, I just thought
I let you know, so you can look at your pattern.
see attached, I highlighted the flaws.

You never know what you are going to find.

Perry B.

Attached is a magnified pic of the rope pattern in the pattern editor. I don't see any flaws anywhere. There is nothing mirrored in the pattern either. It must be a glitch in the program?

[myshop1044]

You are correct, I just copied and pasted the rope onto a new project and nothing appeared.
Then I laid in a sand ptn for the texture and the feather showed up, I turned off the feather and it went away.
Thanks again.

Perry B.