Need assistance: I just bought a another used carvewright with problems. I was told it was a board sensor issue which I've dealt with before, but before I even get to it, I'm getting a z axis error - won't move at all. I think the issue is the ribbon cable that attaches to the back of the truck - it's loose - like it was pulled out. I can see the old glue on it. I tried to wedge it in with a thin piece of card board on the side without contacts, but it's not working of course. Is there a part to purchase to fix this? Or should I try reapplying glue (instead of wedging cardboard) and sticking it back in there? I'm afraid the glue would make things worse. Thanks!