I missed up

[aokweld101]

All right I missed up this morning. I took the memory card out with the machine on it was a split second before I turned it off, now when I'm doing the backside of my board it says load board and enter it moves the truck a glitch and that's it, I don't know if I missed the machine up or how to check what I might of missed up...it being Saturday no lifeline today at LHR Could someone help me with this....... I have a another machine to pull parts from if need be.... Thank you

[lynnfrwd]

Reformat your card and reupload the project. (Cross your fingers.)

[lynnfrwd]

Unplug your machine for a few minutes while you do this.

[aokweld101]

I reformatted the project and same thing happened and used a different memory card.. but did not unplug the machine

[peep]

Don't just turn off the machine, unplug it too. So the capacitors have time to discharge. 20+ minutes or more. Then try it again.

[aokweld101]

The led on the panel woks it goes through my projects and does what it should do maybe I need to try a different project with just the front side and see what happens

[aokweld101]

I unplugged the machine... and as Connie said crossing my fingers

[lynnfrwd]

That's a good sign. If it does it on a basic project, look at your x-termination card, but I'm guessing you're fine.

[aokweld101]

I did all that was suggested to no avail so what might be the next step?

[bergerud]

Take the time to explain exactly what the machine does when you try to load and carve a simple project. (Removing the card may not be the cause of the problem.)