I was trying to use the Rotary Jig and keep getting "Calibration error" it shows old : 914 New : 1048
Any I else had this problem.
I was trying to use the Rotary Jig and keep getting "Calibration error" it shows old : 914 New : 1048
Any I else had this problem.
Leo Davenport
Enjoy Life Carve Something everyday
I take it you are getting this on the calibration steps on a dowel?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Yes. When it turns the board around 3 times.
Leo Davenport
Enjoy Life Carve Something everyday
Your number do look like they is a big difference for the old and new. How many times did you try it and did you check your head pressure?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
The jig calibration is very finicky. Make sure the jig is tight against the squaring plate and clamped down as tight as possible under the head. Remove and reclamp until the calibration falls within range.
I tried it 3 times. Its late and I have checked head pressure, I will tomorrow. When it turn the board around it stops about 1/2 turn short.
Leo Davenport
Enjoy Life Carve Something everyday
Thanks. I knew when it went right in no problem some thing would happen
Leo Davenport
Enjoy Life Carve Something everyday