I put a little more time into this modification. It's done entirely in 1.187 and it uses patterns that can be used by anyone. Including the card suits. The text is fully customizable and the only add-on needed is Centerline to carve it as is. If you change the Centerline text to raster or outline the Centerline add-on will not be necessary. You will need two boards about 15" by 6" by .75" (unless you use a sled) and the finished board thickness is around .5" for both top and bottom. Again, I have not carved this project so be sure to examine it carefully if you choose to carve it.