has anyone tried drilling a hole at about .650 and about 12 inches round.....
I tried to do it and it came out oblong.....any pointers??
George,
SC
has anyone tried drilling a hole at about .650 and about 12 inches round.....
I tried to do it and it came out oblong.....any pointers??
George,
SC
Explain how you drilled it. What was the max pass depth set at? Was it shorter in the x direction and wider in the y? Did you use the 1/8" cutting bit?
How accurately does your machine measure the length and width of a known board?
George,
My guess is that it lost board tracking. Was it oblong in the Y or X direction? Were you also doing this in one pass or multi pass?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.