Guru's
I have had a chain of issues with my B machine with about 230 hours on it. As a result I have replaced the QC with a Carvetight, replaced the y drive assembly with a new one (changing the bearings did not clear up the clicking). Now, with the new Y motor assembly installed, on the first carve I get a board sensor error. Run the sensor check and get a value of 151, plenty high from what I can tell from other posts. I had the board sensor problem early in my CW experience and have not had an issue for a couple of months with it.
I have heard that the sensors are chained together, is there something else wrong that is just showing up as a board sensor?
Thanks in advance.
texasinmi