Too Hard, Too Fast

[La Huche a Pin]

Hi

I try to carve a 3/4 inche deep patern in hard mapple. The carvewright try to make the job too fast and the machine stop with message error. I can hear the machine taking too much before the automatic shut-off. I try to increase the quality of the artwork to slower the process but no result.

There's a solution for this like a "click" option for hard wood to tell the machine to slow-down the job. It's really too fast.

- Carving-bit is clean and sharp.
- The machine is lubriquate well.

Regards
Serge

[blhutchens]

When you save the project to the flash save on "optimal". also use a large feather when you design it.