New Rotary Jig

[aokweld101]

Ok, I might give that a try. A Frankenwright!

Dan, when putting your Frankenwright together make sure the palms of the hands face forward...lol

[James RS]

From the picture of the jig, it loos as those the belt rides on the rubber belt.
I'm probably wrong

I think sandpaper would not grip the metal rollers. That's why you need the rubber belts.

[liquidguitars]

Very cool Dan...

[blhutchens]

So does the new software not stop on rotary mpcs when you open the cover?

Is it just my machine or are there more surprises in there we should know about?

[lynnfrwd]

So does the new software not stop on rotary mpcs when you open the cover?

Is it just my machine or are there more surprises in there we should know about?

I think it's your machine....

[blhutchens]

The cut motor stopped but it kept going through the motions and said carving…...

[bergerud]

Mine stops when I lift the cover. Check the left cover switch using the sensor check menu. If it checks out ok, re-flash the card.

[fwharris]

So does the new software not stop on rotary mpcs when you open the cover?

Is it just my machine or are there more surprises in there we should know about?

Press the STOP button one time to pause your carving. This sends the signal to the computer to shut things down. Lifting the cover the cut motor will stop first (or should if the switch is working) and then the computer tries to react to the close cover switch showing open.

[Foggycarver]

Is the jig steel or aluminum ?

[bergerud]

Is the jig steel or aluminum ?

The plates and sprockets-pulleys are aluminum.