Sounds Like a Turkey

[easybuilt]

Awesome Job on the Turkey call. Nice project to start with. Floyd has always been so helpful, I remember calling him so much! Thanks Floyd!!

[aokweld101]

nice turkey call, The results of how it works is when that first turkey gets called in....

[Digitalwoodshop]

Very nice....

I agree for the long term a less of a bite or smaller bit would be better... At some point the Y will slip a tooth during the heavy cuts and the machine could try to cut virgin wood and stall or start a fire... We are talking over 250 cut hours... as the Y gear box bearings wear...

Many of us have battery smoke detectors above the machine.... I had my detector go off one day as I was working out on my deck and the machine runing in the wood shop 10 feet away... The Outer Flex had started to smoke....

AL

[CW-HAL9000]

Congrats, its good to see someone using their CW to make money. Its an inspiration to us all.

[Foggycarver]

Thanks all for the great comments but i never started anything for the money. I gave away more calls than i can count. It's just nice to see people hunt and family spending time together. I do wish to make enough to maintain the carvewright however.

[Foggycarver]

We have been working this weekend on proving out the call box lid. This is my favorite so far, so much fun. A few more adjustments to the v carving is alil too deep and I think it's the final change we are going with.

[Jerrylouismartin]

I have tried to work a pot call on my CW. I would like to talk. Been trying to figure this out, What is the size bit you are using and have you tried doing multiple pots in the same board?