making files

[aokweld101]

How do you get to make a file that is made in 2.004 to make a file in 1.187

[bergerud]

You cannot reverse a 2.0 mpc to be compatible with 1.187. All you can do is create a pattern in 2.0 which will be compatible with 1.187. Make a pattern in 2.0. Close. Open 1.187, the pattern will be in your favorites list. You can now use it in a 1.187 mpc or export it.

[aokweld101]

Thank you Dan, I am getting to learn the 2.004 It is not as hard as I make it out to be, I would like to get a start on the other programs such as mesh lab and the likes, If I could just get to where I could just start a small project, I might be able to make a duck some day.... ...lol

[aokweld101]

just hit my 1000 post and I can't think of a better way than making the 1000 post with you Dan, you have helped me so much, and I do Thank you for putting up with me and all my dumb questions..... your a gentleman and scholar !!!

[bergerud]

Congratulations. Now you can check out the seniors forum.

[RogerB]

Congratulations on the 1000 aokweld101.

[Capt Bruce]

Welcome to the Senior Club Aokweld101. Doesn't really feel any different does it? Just like a birthday anymore but still our congratulations because you made it!

[CW-HAL9000]

Congrats on becoming senior member, I still have a long ways to go and judging by how long it took you since you became a member I still have a couple of years! LOL.

[aokweld101]

Its as Capt Bruce said its like a birthday, another year gone....do I feel smarter ?.. Yes and no.... there is still a lot to learn, I can do a lot of things That in the beginning I couldn't do, when here on the forum at first the only thing that they spoke was Greek, I'm starting to talk Greek like the rest of them now.... lol