Dust Shoe Attempt

[FWMiller]

Yes. Loaded the files one at a time following the instructions you posted in your thread.

[bergerud]

I guess the x is another problem. The y should have lined up. Dust in the y encoder? I am at a loss.

[NLAlston]

Did you see what happened? Did the bit slip out of the chuck? I do not think the project is responsible. It is some easy cutting. Go and buy an upcut, two flute, router bit like the one in the picture. It will cost about $20 but you need not fear it breaking.

I had wondered about cheaper alternatives. Good to know this.