I was carving and the error check back roller press enter to continue.so I check and press enter the machine continues with the project but will not clear the error message unless you turn off the power.it has happened twice now any suggestions?
I was carving and the error check back roller press enter to continue.so I check and press enter the machine continues with the project but will not clear the error message unless you turn off the power.it has happened twice now any suggestions?
I would start with a reformat of the flash card.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Reset the power and load a board. On the Keypad, call up sensor data and the roller data.... As you crank the head down on the board and up off the board you should see the state change on the LCD.
Remember a Roller that does not come un compressed or released could be resting on some sawdust on the flat plate that the released roller rest on. It builds up over time and does not let the switch tang fall into the slot.
Use Extreem Care if you remove the Keyboard Side to clean the plate as you can tear the keypad wires.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
[QUOTE=Digitalwoodshop;219861]Reset the power and load a board. On the Keypad, call up sensor data and the roller data.... As you crank the head down on the board and up off the board you should see the state change on the LCD.
Remember a Roller that does not come un compressed or released could be resting on some sawdust on the flat plate that the released roller rest on. It builds up over time and does not let the switch tang fall into the slot.
Use Extreem Care if you remove the Keyboard Side to clean the plate as you can tear the keypad wires.