Senior Member
Did I miss a memo in Version 2?
I'm still trying to get acquainted with the new software.
My current project I'm starting is a frame with a 1/2" rounded edge.
If I make it in Ver. #1 I see what I expect.
If I create it in Ver. #2, or use a copy from Ver. #1, I get something else.
What am I doing wrong?
A previous project with big letters had wide margins around each letter rather than being right on the edges.
I don't understand that either.
I'm not liking what I'm getting with the new-and-improved!
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
Senior Member
Floor feather? A little checkbox up by the Conform checkbox.
Senior Member
Thank you bergerud!
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
Senior Member
Now for the second part
Why is the "frame" around the letter so far away?
If I attach the letter to the edge (0.00), the letter is about a half in (or more) from the edge.
Positioning the letters is confusing.
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
Posting Permissions
Reply With Quote