I downloaded the basic software and how do I use the patterns that come up on rightside of the page do I need a license to use those patterns
I downloaded the basic software and how do I use the patterns that come up on rightside of the page do I need a license to use those patterns
more info ,is it a new machine ,if it is the basic software you don't need the license , you left click and drag to the board
Henry
Every one has a photographic memory. Some just don't have film.
the projects that are on the right side come with designer and you can use them.
You might want to spend some time reviewing the software tutorials http://www.carvewright.com/support-p...ject-designer/
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Tell us where you're located, there might be someone close to you that could assist you.
Yep That did it click and drag Thanks for all the help.
It's a Rev A and never has been used but will be soon
You can set depth of pattern in designer. When you start your machine it will calibrate your bits. Check out the tips and tricks. http://forum.carvewright.com/content...ips-amp-Tricks many good starting points in them. Saves frustration when you make an already known mistake. Lots of reading but well worth it.
The depth of a pattern defaults to match the thickness of it. A 1/4" thick pattern will go to a depth of 1/4". You can adjust the depth and the height. 100 Height is the original thickness, in this case 1/4".
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Ok on the pattern and do I have to go over every point to tell it the depth and what bit to use.
This what I bought SKU : 0026-01-0003657 Deer Feeding. I will be engraving it on a board 4 feet long 12 inches wide and 1 inch thick I don't want the carving to deep lets say 1/4 inch deep, how will it know the high points and all the trees and the landscape or will the machine know.