Any body had their machine to stop when it went to cross cut a board??
It's been about 5 months since I did any carving or cutting with it.
Guess I got to do some greasing and fighting to it before I start doing an actual carving.
Junior Member
Hesitation!!
Any body had their machine to stop when it went to cross cut a board??
It's been about 5 months since I did any carving or cutting with it.
Guess I got to do some greasing and fighting to it before I start doing an actual carving.
CarveWright Staff
I don't know too many people using it to cross cut a board. Any error messages?
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Senior Member
Hey Buddy !!!!
Sounds like the machine is COLD.....
A little WD 40 on the roller rail bearings and what is the condition of the Y Gear Box?
Take Care,
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Posting Permissions
Reply With Quote