-
Tip: Add this to your maintenance schedule
I may be a little more heavy handed than most when tightening my bits ( I like TIGHT bits), but you want to avoid this if you can.
I would say every 500 to 750 change this little guy out so you don't end up drilling out a broken one like I did. It is stretched a little every time you tighten it. It cost me about a half hour of production today but I guess it could have been worse.
Last edited by TerryT; 12-07-2013 at 08:39 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules