Can the 2" bits be used with 1.187? Seems there would need to be a change in the bit choosing list.
Clint
Can the 2" bits be used with 1.187? Seems there would need to be a change in the bit choosing list.
Clint
No, it requires designer+firmware 2.003 or higher.
Announcement coming out today???
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
See the build blog....
I did plus knew it was coming.. Just did an update check through designer and it is up for down load...
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
So with this out now what are the rules/limitations on the new bits?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Almost like ice picks! Since you are a beta tester did you run any tests with these? Looking at the description in the store it only states to use best or optimal settings. Any other insight?
I know for the normal 1/8" carving bit it state for soft materials only...
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I think I see a typo:
The CarveWright 1/8" Long Carving Bit allows for 2" deep carvings.
Max cutting depth with this bit is 2.125 inch.
The 1/8" long carving bit comes with a CarveTight adapter
only
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.