Please remember the colder weather can affect your machine, so warm up those shops. Also, please ground yourself before touching the machine to avoid zapping your controller, memory card and any other electronic parts.
Please remember the colder weather can affect your machine, so warm up those shops. Also, please ground yourself before touching the machine to avoid zapping your controller, memory card and any other electronic parts.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Cold here too in Ohio, 30° and snowing like....it's Christmas time...
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
If you have a small space heater set it up so it blows warm air into the machine for about 10-15 minutes. Just make sure it is far enough away that you are not over heating it...
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I keep my machine in my basement since the shop is a detached garage and way too cold... not to mention there is no room from my lil' machine out there...
I keep a small space heater and laser thermometer in the basement and check the machine in the winter and bring it's surface temps up to at least 55-60 degrees before running it
Good tip!
29 degrees this morning in North Texas - Heater on in the shop - must have during the cold months.
+1 on the surface temps of 55-60 before running.
16 deg this morning here
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie