Here's my shot at it - hopefully this is what you were wanting.
Here's my shot at it - hopefully this is what you were wanting.
That looks pretty nice Chief.
Thanks guys for the help. Off to the shop to carve.
Test run on pine came out great. Been fighting with the sensor to run it on cedar all afternoon. Cant wait to get final carve to install on my ice chest.
Try masking tape on the edges the sensor measures.
Be sure to clean the board sensor after each carve, especially if you do not have dust collection.
+1 on taping edges. Darker wood can be tricky at times
I took the sensor apart several times and cleaned with alcohol and got all of the dust off. Still would not recognize the edges until I put the tape on the edges. I will paint the swirl tonight and post a pic tomorrow. I did get a couple of others carvings off. Here is one for my little cousin xmas present I was able to finish tonight.
Thanks again to all for the help!!!!
Coby
Looks nice!
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
i use old toothbruush to clean sensors no need to disasemble just feel sen. with fingers and brush away
denny