I attempted, maybe this will do.
aokweld101
that is good, I'm not a good pattern maker myself. I did an invert on the pattern and looked what happen.
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
I had gotten advise from someone on the forum that if you go into the pattern editor and use the blur tool and the smoothness tool... but on the average don't go over three on the blur tool...... if I'm not mistaken I think edlamb give me that advice If not I apologize I would like to give the credit where the credit is due.
Sorry AOK that was not me on that advice.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
That is awesome thank you, but how do I learn to do that?
I'm sorry eelamb, There is so much advice here on forum I don't know where I here it from at times.