Results 1 to 5 of 5

Thread: STL Help

  1. #1
    Join Date
    Feb 2007
    Location
    Upstate NY USA
    Posts
    952

    Default STL Help

    I have a stl file I imported and I was wondering if there'd be a way to
    make vector paths of the pattern. I'd like to speed up the process
    using a 3/8" round nose bit, I have a few of these to make.
    I tried to upload the file, it's too large

    Thanks
    Jim
    " The Hurdier I Go, The Behinder I Get"

  2. #2
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    It is hard to know what you want to do without the file or a picture. Could you post a screen capture?

  3. #3
    Join Date
    Feb 2007
    Location
    Upstate NY USA
    Posts
    952

    Default

    Here it is at a angle
    Click image for larger version. 

Name:	8 inch.jpg 
Views:	92 
Size:	64.9 KB 
ID:	65506
    " The Hurdier I Go, The Behinder I Get"

  4. #4
    Join Date
    Nov 2008
    Location
    Vancouver Island
    Posts
    8,193

    Default

    So you want to be able to "carve" with the 3/8 round nose. I do not think there is a way. You would have to make a large number of different paths to be routed at different depths. It would probably take longer anyway. I think your best bet is to use the 3/16 ball nose as the pattern bit.

  5. #5
    Join Date
    Feb 2007
    Location
    Upstate NY USA
    Posts
    952

    Default

    Ok I'll look into that
    " The Hurdier I Go, The Behinder I Get"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •