Here are three custom patterns I just finished for a forum member.
Here are three custom patterns I just finished for a forum member.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Looks great Eddie!!!
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
great job Eddie, you make some nice patterns..
Thanks Steve, no ideal on camping signs, well I did make the paddlehead sign, and it would be a great one for camping.
For this sign, you or anyone else will have to pm me with an email address. I will not post the pattern here.
EDIE: Doug, this one was all ZB, projection master, and sculpting, then sliced the back off in designer stl importer.
Last edited by eelamb; 10-01-2013 at 04:56 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Thanks Roger.
Here is one I made using a vector dxf file Steve gave me. I had to redraw it to make it symmetrical but I think it came out very good at that.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Excellent! Seems like I just emailed it and you were finished already!
Steve
Centerline
Pattern Editor
Conforming Vectors
DXF Importer
STL Importer
2D Advanced Tools
Designer 1.187, 2.007 and **NONE** on Mac OS 10.15.6 and Windows 10 via Parallels on Mac
Wow nice one eelamb that was fast
That is nice Eddie, It is as easy as the add for carvewright said, pull, tug push and carve... right good buddy?....lmao
Zan29, the pen does not do a lot for MoI3D, but if you like it, go for it. I use 2 monitors, and a wacom pen tablet Graphite (mostly the pen in ZBrush).
Steve, thanks for the comment. You mentioned v carve pro, do you have aspire? I understand this type of chip carving is much easier in aspire or artcam. Doing this in MoI3D using sweep is time consuming to say the least.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
No Aspire. I wish I did. VCarve Pro is pretty good.
Steve
Centerline
Pattern Editor
Conforming Vectors
DXF Importer
STL Importer
2D Advanced Tools
Designer 1.187, 2.007 and **NONE** on Mac OS 10.15.6 and Windows 10 via Parallels on Mac