I am finally getting a round tuit. I have it all carved (except the knobs - I will make my own on the CarveWright) but I have hardware questions. I the previous thread people said the they ordered the roller and bearings. What exactly am I looking for and also the two bearings for the dowel? And what is the purpose or the lift lever? A spring goes under the roller lift, I understand that part, but are there any other spring needed? How are the slide plates held in place? I see a screw with washer holds the left one from falling out, and I assume the pressure from the dowel holds the left one, but what holds them from moving up and down?
Thanks