Rotary Jig Prototype II revisit.

[Russel]

I have been silent for several weeks about the rotary jig II that I built. Previously, a problem occurred when I tried to initiate a carve operation. I never was able to have the board edge sensor give an acceptable reading. After letting the problem sit for some time, I tried to adjust the sliding plate. Now, I get a board sensor reading of 162, which is good. However, when I attempt to initiate the carve, I still get the message to check the board sensor. What am I missing? Has anyone else built one and seen this problem? If so, what is the solution? The jig positioning is correct.

It looks like I need to read a little further down, before commenting.