Here is a paddle pattern. Not sure if it is the same one.Paddle.mpc
Here is a paddle pattern. Not sure if it is the same one.Paddle.mpc
Hey Perry, You are doing awesome work! Good luck at the show!!!
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Thanks again for your comments, Hope, the paddle is my design. it is a simple layout that have been paying with. It is 15" long and width is 3". I use a sled
to save wood. board is 3 1/2" by 16". I do a 2 sided carve using puffing on both sides. The top side is more flat to allow for the pattern I added on the paddle.
I am headed to the Shrimp and Petroleum Festival in Morgan City, about 30,000 people in 3 1/2 days, it's a long show.
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Perry, I hope you made a couple hundred of those!!! They are gonna fly off the shelf!!! Those are very nice.