Ok, here is the issue…
I carved a few items and they came out fine (narrow stock). I then went to carve a wide (12") piece and it carved lopsided – far (non-keyboard) side deeper than near side. So I realized that the head was out of alignment (by about 1/8”). Apparently it has been like this since day one. And with narrow stock it was never noticeable.
So this is what I did…
- Realigned head
- Tested it – FAILED
- Realigned head
- Tested it – FAILED
- Realigned Head
- Tested it – FAILED
Now my question is: if when I realign the head again if I purposely lower the near side will it result in any issues with other components (truck, bits, compression rollers)?
Thanks in advance for any advice.
Bob