Sorry to bother you foks, and I know it is here somewhere, but I am looking for the size of the o-ring for the brass tracking sensor, any know the correct size.
thanks in advance..
Sorry to bother you foks, and I know it is here somewhere, but I am looking for the size of the o-ring for the brass tracking sensor, any know the correct size.
thanks in advance..
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Many thanks it was driving me crazy that I could not find it....
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I recall sometime ago being told that the O ring is not really necessary to replace
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
I'm not sure it would be necessary to replace mine, but I would. My brass roller leaves an imprint on my boards deep enough I don't think there is much chance of slipping. Every machine seems to be different, however - CWs are inconsistent if nothing else!
I hope someone out there will be able to help me; I get a check tracking roller error when I try to do a project. I have visually inspected the roller and it looks fine…any ideas. It worked a day ago.
Thanks for any help
Things to check:
out feed trays out of alignment, raised to high lifting board off of the tracking roller
Sandpaper belt rolled over on the end on keyboard side
Low head pressure
and the troubleshooting guide.. http://www.carvewright.com/support-p...racking_roller
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Funny thing is... my tracking roller never leaves a mark, even in pine or mdf. I think it is missing the rubber part below it. So it is functioning on spring pressure only. I always make sure the boards I use are jointed, planed, and squared. I aslo "ALWAYS" use 4 or five strips of sandpaper, one on the edge for the tracking roller.
"Carved with Love"
Happiness comes from within.
But joy comes from helping others.
Measure twice... and then sneak up on it!
Thank you, I will check it out.