I didn't think about OS, but I am using Windows 7, the file was created on an XP machine.
I didn't think about OS, but I am using Windows 7, the file was created on an XP machine.
It opened fine in my 1.187 on Windows 7... Good luck finding the problem.
Last edited by Geomoo1; 07-06-2013 at 12:19 PM.
George
opened fine with 1.184
steve
Start U Member
Blows that theory. XP Pro SP3 1.187 original file opened just fine.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Opens in 2.01. Win 7
I upgraded every driver I could without luck.
So, now I'm just trying to see if I could start over, and as a test, just laying drill holes out on a normal grid. I can only get to about 450 holes before it crashes. Nowhere near 1113!
I then saved a file with 400 holes in 1.187 and it will not open in 2.01. After 400 holes, pasting fewer holes at once usually will let you get to more holes before crashing.
Starting new with 2.01, it appears my limit of holes is around 300.
Last edited by brdad; 07-06-2013 at 03:52 PM.
How much RAM does everyone have that does and does not open?
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Last edited by lawrence; 07-07-2013 at 01:20 AM.