I have been busy carving Dan's Rotary Jig II. I have yet to figure out how it all works, even after I get it assembled. There are a few items that, although are shown in the photos, are not obvious to me. They are:This jig is awesome and well thought through. I carved it mostly in one day. If anyone has info on projects and general jig operation, I desperately need it!
- What material was used for the axle slides? They appear to be wood, but much darker than the rest of it. Are they hardwood?
- What are the specs for the spring?
- What type of knob was used for tightening the slider?
- I can't find the rails in the photos. Where do they fit in?
- How does this jig mate with the CW?
- What should the workpiece look like?