I was so excited about being able to rotate the board 90 degrees to see your project in portrait without getting a crick in my neck.
Now, I'm even more excited that the next release will have the ability to turn the back side of your board 180 degrees, so you can go from front to rear 180 and make sure your two-sided card is lined up properly.
Just remember to roll it over in the machine, not flipping end to end.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!