-
Prayer of St. Francis
Has anyone carved the Prayer of St. Francis from the PatternDepot? If so, which setting did you use: optimal, best, normal? The board I am using will let me carve three copies but the carve time gets lengthy if I run optimal (11+ hrs to finish all three). Best is a bit better at 5+ hrs and normal comes in at 3+. Using pine. I generally prefer optimal but the time needed isn't 'optimal'.
Thanks for any thoughts,
David
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules